Residual Risks - Nordcap MORETTI P Serie Mode D'emploi

7

RESIDUAL RISKS

RESIDUAL RISKS
Description
Slip or fall
Burns
Burns
Electric shock
(Electrocution)
Electric shock
(Electrocution)
Falls from a height
Load tipping
Chemical
Cuts
Crushing
Ergonomic
DANGEROUS SITUATION
Description
The operator could fall due to presence of
water or dirt on the floor.
The operator intentionally touches parts
of the equipment.
The operator intentionally touches high-
temperature cooking methods (oil, water,
steam....)
Contact with live electrical parts during
maintenance operations carried out with
electrical control panel under voltage. The
operator intervenes (with an electric tool
or without disconnecting the machine's
power supply) while lying on a wet floor
surface.
Electrocution caused by malfunctioning
grounding system or electrical protection
devices.
The operator intervenes on the machine
using unsuitable equipment to reach the
upper part (for example, using a ladder or
by climbing on top of it).
Movement of the equipment, or part of it,
without suitable means.
Operator comes into
chemicals (e.g.: detergent, descaler, etc.)
Cuts are possible when in contact with the
internal parts of the machine frame during
maintenance work.
The operator risks crushing fingers or hand
in the handling of moving parts.
The operator intervenes on the device
without the necessary personal protective
equipment.
Description
During equipment use, operators must
use anti-slip personal protective
equipment.
During equipment use, operators must
use personal heat protection equipment.
During equipment use, operators must
use personal heat protection equipment.
Maintenance of the equipment must only be
carried out by qualified personnel equipped
with personal protection equipment against
electrocution.
Install protection devices compliant with
current regulatory requirements upstream of
the equipment.
The operator does not intervene on the
machine using suitable equipment to reach
the upper part (for example, using a ladder or
by climbing on top of it).
When moving and handling the equipment or
its packaging, use suitable lifting accessories
or systems.
Use appropriate safety measures. Always
refer to the safety data sheets and labels of
contact with
the product used.
Use personal protective equipment
recommended in the safety data sheets.
Maintenance should only be carried out by
qualified personnel with personal protective
equipment (cut resistant gloves and clothing
covering the forearm).
Maintenance should only be carried out by
qualified personnel with personal
protective equipment (gloves).
The operator must intervene on the
device wearing adequate personal
protective equipment.
UK/12
WARNING