Twisted Pair Cabling - Leviton 41920-CP8 Mode D'emploi

41920-CP8
6. Connect the 3.5 mm plug of the supplied IR emitter to the IR OUT port of the 41910-HTR
HDBaseT Receiver
7. Locate the IR target on the display device you wish to control. These are sometimes hidden
behind a dark piece of plastic. Use a flashlight if necessary to locate its exact location.
8. Peel the paper from the front of the IR emitter and stick it directly over the IR target on the
display device

Twisted Pair Cabling

For best performance, twisted pair cable should be installed in accordance with TIA-568-C.0 and
NEC 300 and field certified using ANSI/TIA-568 UL approved testers
NOTE: Leviton recommends Category 6A cabling for best performance
Control Panel
Adapter Cable
41920-CP8
Rear View
Autoswitching Wallplate
Adapter Cable
41920-HRC
Rear View
8
Category
Cable
DI-060-41920-25A