Generac GC2800B Manuel De L'utilisateur page 25

2. See Figure 4-13. Remove two bolts, lock washers,
and flat washers (C) securing belt guide (D) using
a 13mm wrench. Remove belt guide.
C
Figure 4-13. Removing Belt Guide
3. See Figure 4-14. Remove the two bolts (E) secur-
ing transmission cover (F) using a 10mm wrench.
Figure 4-14. Transmission Cover Bolt Locations
4. See Figure 4-15. Roll front auger belt (G) off front
of engine drive pulley (H) and rear auger belt (I) off
the back of engine drive pulley.
J
Figure 4-15. Engine Pulleys
NOTE: A 13mm wrench may be used on the engine
shaft bolt and turned clockwise to aid in rolling belts off
the pulley.
5. Remove traction drive spring (I) from the frame
using pliers.
6. Remove traction drive belt (J) from engine pulley
and let it rest in front of the pulley.
Owner's Manual for Snow Blower
D
011101
E
F
011102
H
G
I
011108
7. See Figure 4-16. Observe how end tabs (K) of the
friction disc bracket are located on both sides of
the front strut. It must be installed this way when
reassembled.
Figure 4-16. End Tabs of Friction Disc Bracket
8. See Figure 4-17. Remove bolts, lock washers, and
flat washers (L) securing front strut to frame. The
friction disc bracket will now move out of the way
for belt removal.
E
Figure 4-17. Removing Front Strut Hardware
9. Remove traction drive belt from drive pulley and
pull it up so it can be removed from the pulleys on
the engine shaft.
10. Install new traction drive belt onto pulleys.
11. Secure front strut to frame with bolts, lock washers,
and flat washers.
12. Verify friction disc bracket end tabs are on both
sides of the strut.
13. Install traction drive spring to the frame.
14. Install front and rear auger belts onto the pulleys.
15. Install transmission cover.
16. Install belt guide and belt cover.
Maintenance
K
011109
L
F
G
010734 011103
21