Checking And Replacing Auger Shear Bolts; Checking The Auger Shear Bolts; Replacing; Replacing Auger Belts - Generac GC2800B Manuel De L'utilisateur

Checking and Replacing Auger Shear
Bolts
Remove the shear bolts from the auger shafts and visu-
ally inspect them. If the shear bolts are worn excessively,
or if they are broken or missing from the auger shaft,
they must be replaced.

Checking the Auger Shear Bolts

Proceed as follows to check auger shear bolts:
1. See Figure 4-4. Remove shear bolts and locknuts
(A) using two 13mm wrenches.
B
Figure 4-4. Checking and Replacing Auger Shear
2. Inspect shear bolt condition.
• If shear bolts are not worn excessively or dam-
aged, they can be reinstalled.
• Replace excessively worn or damaged shear bolts.

Replacing

Proceed as follows to replace auger shear bolts:
1. If shear bolt hole is not visible, turn auger (B) until
holes in the auger and auger shaft line up.
NOTE: If shear bolt ends are sheared off, push remain-
der of bolt out with a punch.
2. Install new shear bolts and cotter pins once holes
are aligned and clear.
Owner's Manual for Snow Blower
A
011099
Bolts

Replacing Auger Belts

Proceed as follows to replace auger belts:
1. See Figure 4-5. Remove the two bolts and rectan-
gular washers (A) from belt cover (B) using a
10mm wrench. Remove belt cover.
Figure 4-5. Removing Belt Cover
2. See Figure 4-6. Remove two bolts, lock washers,
and flat washers (C) securing belt guide (D) using
a 13mm wrench. Remove belt guide.
C
Figure 4-6. Removing Belt Guide
3. See Figure 4-7. Remove the two bolts (E) securing
transmission cover (F) using a 10mm wrench.
Figure 4-7. Transmission Cover Bolts Location
Maintenance
B
A
011100
D
011101
E
F
011102
19