Electrical Safety - Black & Decker KW1600 Mode D'emploi

ENGLISH
•
Injuries caused by touching any
rotating/moving parts.
•
Injuries caused when changing any parts,
blades or accessories.
•
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
•
Impairment of hearing.
•
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
Vibration
The declared vibration emission values stated in
the technical data and the declaration of
conformity have been measured in accordance
with a standard test method provided by
EN 60745 and may be used for comparing one
tool with another. The declared vibration
emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly using
power tools in employment, an estimation of
vibration exposure should consider, the actual
conditions of use and the way the tool is used,
including taking account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle in
addition to the trigger time.
10
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.

Electrical safety

This tool is double insulated; therefore
no earth wire is required. Always
check that the power supply
corresponds to the voltage on the rating plate.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Features
1. On/off switch
2. Lock-off button
3. Handle
4. Variable speed control knob
5. Plunge lock lever
6. Spindle lock button
7. Collet
8. Revolver depth stop
9. Depth stop bar
10. Chip deflector
11. Dust extraction adaptor
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.