Trouble Shooting - Harvey MW TECH TZLI30M Mode D'emploi

M1.1.TZLI30M-TZLI30MRT.NLFREN - 12022019
EN

11 Trouble shooting

Problem
Saw will not start
Overload kicks out frequently
Does not make accurate 45° and
90° rip cuts
Material pinches blade when
ripping
Material binds on splitter
Saw makes unsatisfactory cuts
Blade does not come up to speed
Machine vibrates excessively
Blade does not raise or tilt freely
Possible cause
Saw not plugged in
Fuse blown or circuit breaker tripped
Cord damaged
Extension cord too light or too long
Feeding stock too fast
Blade in poor condition (dull, warped,
gummed)
Blade binding due to misaligned rip fence
Blade binding due to warped wood
Low house current
Positive stop(s) not adjusted properly
Tilt angle pointer not set properly
Rip fence not aligned with blade
Warped wood
Splitter not aligned correctly with blade
kerf
Dull blade
Blade mounted backwards
Gum or pitch on blade
Incorrect blade for work being done
Gum or pitch on table causing erratic feed
Extension cord too light or too long
Low house current
Motor not wired for correct voltage
Table not mounted securely to cabinet
stand
Stand is on uneven floor
Damaged saw blade
Bad V-belt(s)
V-belts not tensioned properly
Bent pulley
Improper motor mounting
Loose hardware
Sawdust or dirt in raising or tilting
mechanisms
Solution
Plug in saw
Replace fuse or reset circuit breaker
Have cord replaced by a certified
electrician
Replace with adequate size cord
Feed stock more slowly
Clean or replace blade
Check and adjust the rip fence. See rip
fence instructions
Select another piece of wood
Contact your electrical company
Check blade with square and adjust positive
stop
Check blade with square and adjust pointer
to zero
Check and adjust rip fence
Select another piece of wood
Check and align splitter with blade kerf
Replace blade
Turn blade around
Remove blade and clean with turpentine
and steel wool
Change the blade
Clean the table with turpentine and steel
wool
Replace with adequate size extension cord
Contact your electric company
Refer to motor and /or nameplate
Tighten all mounting hardware
Reposition on flat level surface
Replace blade
Replace V-belt(s)
Adjust V-belt tension
Replace pulley
Check and adjust motor mounting
Tighten all nuts, bolts and set screws
Brush or blow out loose dust or dirt
61