Miter Gauge - Harvey MW TECH TZLI30M Mode D'emploi

Rails
1. Install the front rail onto the table and extension wings with (4) M8-1.25 x 40
mm hex bolts, (8) 8 mm flat washers, (4) 8 mm lock washers, and (4) M8-1.25
hex nuts. (See Figure 6)
2. Install the front rail tube onto the front rail with (3) M6-1 x 16 mm cap screws,
6 mm flat washers, and 6 mm lock washers. (See figure 7)
3. Install the rear rail to the holes on the main table using (2) 5⁄16"-18 x 1" hex
bolts, 8 mm lock washers, and 8 mm flat washers.
NOTE
!
As with the front rail, make sure the rear rail is parallel with
the table top and below the miter slots before fully tightening
the fasteners. (See figure 8)
Fence
Place the Fence on the rails on the right hand side of the blade. (See figure 9)
NOTE
!
The cam foot must contact the cam on the fence lock handle
before you place the fence on the rail, otherwise the fence
will not lock onto the rail tube.

Miter Gauge

Slide the miter gauge into the T-slot on the left hand side of the blade.
(See figure 10)
M1.1.TZLI30M-TZLI30MRT.NLFREN - 12022019
Figure 6 - Install the front rail
Figure 7 - Install the front rail tube
Figure 8 - Check the location of the
rear rail
Figure 9 - Fence installed on rail
Figure 10 - Miter gauge attached
50
EN
Equal