Description (Fig. 1); Control Panel (Fig. 2) - S&P AIRPUR 2N Mode D'emploi

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY DAMAGE TO PEOPLE AND/OR PROPERTY DUE TO NON-COM-
PLIANCE WITH THESE WARNINGS.
S&P RESERVES THE RIGHT TO MODIFY THE PRODUCT WITHOUT PRIOR NOTICE.

2. DESCRIPTION (Fig. 1)

a. Back cover.
b. Fiber fi lter + HEPA H13 + active carbon.
c. Unfi ltered air intake.
d. Panel / control panel.
e. Filtered air outlet.
f. Transport handle.
g. Safety switch(back cover).
3. COMMISSIONING
Follow the steps below in order:
• Remove the appliance from its packaging. Do not leave the packaging within the reach of children and deposit it in
compliance with current recycling regulations.
• ¡ATTENTION! To protect the fi lter, it comes from the factory inside the appliance and protected in a plastic bag THAT
MUST BE REMOVED BEFORE FIRST USE.
• Open the back cover (Fig. 1a) by pulling on the top of it and access the fi lter.
• Remove the fi lter protection bag (Fig. 1b) and replace the fi lter inside the purifi er, with extraction tab on the accessible
side (Fig. 1h).
• ¡ATTENTION! Do not leave the plastic bag within the reach of children.
• Replace the back cover, ensuring that the cover correctly touches the safety switch (Fig. 1g).
• Before connecting the power cable to the mains, make sure that the supply voltage matches the one indicated on the
nameplate of the appliance.
• Make sure that the appliance is placed fi rmly on the fl oor and separated from objects that obstruct the free circulation
of air.

4. CONTROL PANEL (Fig. 2)

ON/OFF: When the appliance is connected to the network, press ON / OFF and the purifi er will start automatically
at low speed.
MANUAL MODE: You can select up to 3 air purifi cation speeds (slow / medium / fast). The corresponding light
indicator will indicate the chosen speed (Fig. 2e).
SLEEP MODE: The appliance will operate at the lowest speed to minimize noise. The corresponding light indica-
tor will indicate that the sleep mode is activated (Fig. 2g). Pressing any option (except ON / OFF) the device will
exit sleep mode.
Pressing the "display" key the control screen will automatically turn off to preserve the darkness of the room. By
pressing the key again, the screen will return to its initial state.
TIMER MODE: By pressing the timer mode consecutively, you can program the operating hours you want (1-2-3...
.12 hours). The counter of the light panel will indicate the remaining time for the automatic disconnection of the
air purifi er (Fig. 2b).
EN
9