Assembling The Headlight System - Sunoptics Surgical LIT051 Mode D'emploi

REAR CRANIAL
SUPPORT (RCS)

3. ASSEMBLING THE HEADLIGHT SYSTEM

Before continuing remove the protective caps.
To attach the fiber optic cable, insert the instrument end into the headlamp module
until it snaps in place. A bifurcated cable fits into the cable clips on both sides and
rear of the headband.
To remove the cable from the headlight module, grasp the body of the module in
one hand and the silicone junction of the cable in the other and pull up. Do not pull
the cable by its legs.
Remember, the fiber optic cable is made of glass fibers. When adjusting the cable
on the headband, do not bend the cable at an angle of more than 60 degrees.
Next, place the headband on your head with the Rear Cranial Support sitting
comfortably on the back of your head; you can make size adjustments by turning
the knob on the rear of the headband until it feels comfortable. Then adjust the top
knob on the Sagittal strap for more comfort.
Once the headlamp module and cable are connected, the unit is ready for use. The
headlight is provided with two prepackaged, sterile, and disposable joysticks. The
LIT051Sunoptics Surgical
(English)
HEADLIGHT MODULE
®
SAGITTAL STRAP
F/O CABLE
SILICONE
JUNCTION
Rev. F
Date of Revision:12/11/13
Page 4 of 40
JOYSTICK