Technical data and certification
1
Technical data
1.1 Keyboard
Bezeichnung/Designation/
Désignation
Spannungsversorgung/Power
supply/Tension d'alimentation
Stromaufnahme/
Current consumption/
Consommation de courant
Lagertemperatur/
Storage temperature range/
Température de stockage
Betriebstemperatur/
Operating temperature range/
Température de fonctionnement
Abmessungen/Dimensions/
Dimensions
1.2 Smartcard reader
Bezeichnung/Designation/
Désignation
Kartenleseeinheit/
Card reading unit/
Lecteur de carte
Protokolle/Protocols/Protocoles
1.3 Fingerprint sensor
Modell/Model/Modèle
G83-14400, G83-14500
G83-14450, G83-14550
G83-14600, G83-14700
2
Certification
2.1 Declaration of CE Conformity
We, ZF Electronics GmbH, hereby declare that the key-
boards RS 14400USB-FPR and RS 14600USB-FPR ful-
fill the following requirement:
•
EMC Directive 2004/108/EC (directive on
electromagnetic compatibility), tested in accordance
with EN 55022 and EN 55024
Tested in accordance with ZF Electronics standard test
procedure.
4
Wert/Value/Valeur
5 V/DC ±5 % SELV
typ. 120 mA
–20 °C ... +60 °C
0 °C ... +50 °C
455 x 195 x 54 mm
Wert/Value/Valeur
100 000 Steckzyk-
len/insertions/cycles
d'insertion
T=0, T=1, S=8, S=9,
S=10
Sensor/Sensor/Capteur
UPEK TCS1
UPEK TCS2
AuthenTec AES2501B
2.2 Hinweis zum GS-Zeichen
Aufgrund der Position der Nulltaste des Nummernfelds ist
die Tastatur für Saldiertätigkeiten, die überwiegend blind
erfolgen, in Deutschland nicht anzuwenden. Eine Tasta-
tur mit nicht-deutscher Tastenknopfbelegung ist in
Deutschland aufgrund der Zeichenbelegung (DIN 2137
Teil 2) nicht für den Dauereinsatz an Bildschirmarbeits-
plätzen zu verwenden.
2.3 Federal Communications Commission
(FCC) Radio Frequency Interference
Statement
Information to the user: This equipment has been tested
and found to comply with the limits for Class B digital
device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorientate or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/
TV technician for help.
Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
2.4 For UL
For use with Listed Personal Computers only!