Attaching Coupler To Regulator; Attaching Regulator To Co 2 Tank - Homecraft KEGERATOR BK49BS Manuel D'instructions

ATTACHING COUPLER TO REGULATOR

1.
If not already inserted, insert the
CO 2 Directional Washer into the
Keg Coupler. Then screw the CO 2
Line onto the Keg Coupler.

ATTACHING REGULATOR TO CO 2 TANK

IMPORTANT! When you purchase your first keg of beer, you must also have
your CO 2 Tank filled by a local supplier. CO 2 Tanks can be filled at locations such
as welding supply shops, party stores, and wherever kegs are purchased.
1.
Align and hook the 4 holes of the
CO 2 Tank Holder with the screws
on the back of the unit.
3.
Use an adjustable wrench (not included)
to attach the Regulator to the CO 2 Tank.
2.
Push the other end of the CO 2 Line
through the hole in the rear of the cabinet.
Slide a Hose Clamp onto the end of the
CO 2 Line, then attach the hose to the barb
fitting on the bottom of the regulator.
Secure the CO 2 Line by tightening the
Hose Clamp with a flathead screwdriver.
2.
Make sure the white nylon High
Pressure Washer (already installed)
is attached to the Regulator.
4.
Place the CO 2 Tank into the
CO 2 Tank Holder.
Hose
Clamp
10