Troubleshooting And Fault Elimination; Troubleshooting; Error Messages - Lenze EPM-H410 Instructions De Mise En Service

Show/Hide Bookmarks
6
6.1
L

Troubleshooting and fault elimination

Troubleshooting

Error messages

Call up the keypad status messages to see the last error message.
Display ( ERROR ) Error
No error
NO ERROR
Faulty data
PR ERROR
exchange
Communication
COM BROK
interrupted
RESET ERROR Communication
with system with system
bus (CAN)
ASIC ERROR
interrupted interrupted
SDO ERROR
Cause
-
Connection between keypad
and PC faulty
Serial data cable between
keypad and PC faulty or not
connected properly
•
Incorrect system bus wiring
(e.g. pole connection) (e g pole connection)
•
Incorrect parameter setting p
for interface (baud rate, f i t f (b d t
address, identifier)
EDBEPM-H410DE/EN/FR 3.0
( ^ 62)
Remedy
-
•
Check connection
•
Check cable
•
Check Sub D plug connection
•
Replace serial data cable
•
Check wiring ( ^ 55 )
• •
Check parameter setting ( ^ See Check parameter setting ( ^ See
g "HMI Designer - Getting Started" g g
Manual ) M l )
73