Danfoss EKC 204A Instructions page 8

The buttons
Set menu
1. Push the upper button until a parameter
r01 is shown
2. Push the upper or the lower button and
find that parameter you want to change
3. Push the middle button until the
parameter value is shown
4. Push the upper or the lower button and
select the new value
5. Push the middle button again to enter
the value.
Cutout alarm relay / receipt alarm/see alarm
code
• Push short the upper button
Fault code display
E 1 Fault in controller
E 6 Change battery + check clock
E 25 S3 sensor error
E 26 S4 sensor error
E 27 S5 sensor error
8
Set temperature
1. Push the middle button until the
temperature value is shown
2. Push the upper or the lower button and
select the new value
3. Push the middle button to select the
setting.
Reading the defrost stop temperature
• Push briefly the lower button
Manuel start or stop of a defrost
• Push the lower button for four seconds.
See HACCP registration
1. Give the middle button a long push until
h01 appears
2. Select required h01-h10
3. See value by giving the middle button a
short push
Alarm code display
A 1 High temperature alarm
A 2 Low temperature alarm
A 4 Door alarm
A 5 Max. Hold time
A 15 DI 1 alarm
A 16 DI 2 alarm
A 45 Standby mode
A 59 Case cleasning
A 60 HACCP alarm
Instructions RI8JP552 © Danfoss 07/2005
LED
Light emmiting diode
= refrigeration
= defrost
= fan running
Flashes fast at alarm
HACCP
HACCP function is activ
Status code display
S0 Regulating
S 1 Waiting for end of the coordinated defrost
S 2 ON-time Compressor
S 3 OFF-time Compressor
S 4 Drip-off time
S 10 Refrigeration stopped by main switch
S 11 Refrigeration stopped by thermostat
S 14 Defrost sequence. Defrosting
S 15 Defrost sequence. Fan delay
S 17 Door open (open DI input)
S 20 Emergency cooling
S 25 Manual control of outputs
S 29 Case cleaning
S 30 Forced cooling
S 32 Delay of output at start-up
S33 Heat function r36 is active
non The defrost temperature cannot be dis-
played. There is stop based on time
-d- Defrost in progress
PS Password required
EKC 204A