Rear Panel - Aguilar DB 751 Mode D'emploi

FX Send:
FX Return:
Effects Loop:
XLR Balanced Output:
Footswitch:

Rear Panel:

Speaker Outputs:
Tuner out:
Sends the signal to your effects units. Connect the input of your
effects unit to this jack
Returns the signal from your effects units to the amplifier.
Connect the output of your effects unit to this jack.
The "Send" knob is push/pull for selecting line or instrument level.
This allows you to use a studio effects unit (line level) or a stomp
box (requires instrument level) in the FX loop. Adjust the amount
of "Send" so as to get maximum performance from your effects
unit and the "Return" to get the right amount of effected signal.
The "Return" knob is push/pull for parallel or series operation.
In parallel mode, the effected signal is mixed to the dry sound. In
series mode, the effects in the loop will process the entire signal.
The amount of effects can be adjusted with the return knob. If
you pull the return knob out for series operation without any
effects plugged in the loop, the loop will be open and no sound
will result.
Use the Pre-EQ setting in a concert situation where the sound
engineer is taking a signal into the house-mixing console. The
engineer is now getting their feed before the preamp stage,
which allows them to use appropriate EQ for the venue. The EQ
on stage will still be controlled by your settings. If the engineer
wants your EQ settings included in the mix, set the control to Post
EQ and your settings on stage will be sent to the house.
The D.I. output is –32dB. This level is the correct output for a
signal going into the preamp on a mixer. Our balanced output
uses the highest quality Jensen output transformer. If you hear
any ground noise, change the position of the ground lift switch
under the output.
Use the optional Aguilar footswitch to mute the signal for silent
tuning.
Two Neutrik Speakon connectors are provided. Use 12 gauge or
larger speaker cable for proper connections.
This output sends the signal to your connected tuner. This output
will still be active when you mute the DB 751.
Page 4