URBANGLIDE ECROSS MAX 2X2 Notice Originale page 26

Remove the rubber cap, insert the charger into the charging port of your scooter. Once loaded, put the cap
back in place and make sure it is secure and waterproof.
When loading your scooter make sure that the loading port is in good condition and that no residue is
trapped inside. If this is the case, clean it with a dry cloth. Use the charger supplied with the product, and
only this charger. If you have lost your charger, or if it is faulty, contact the Urbanglide support. Once the
charger displays a green light, unplug your product. Do not leave the charger plugged in for too long after
charging is complete.
Increase level of Speed/Light
Turn ON/OFF
Decrease level of speed
Load and power supply
Your device is charging. Please wait until the colour
changes.
When the LED is green then your device is charged, unplug
it and also disconnect the charger from its power source.
Screen
20
00001
Battery level
26
3
Speed mode
Speed in km/h | mph
Traveled distance in km