Kobalt SGY-AIR84TZ Mode D'emploi page 9

OPERATING INSTRUCTIONS
3. In this diagram, the hopper is full, the air
is on and flowing, full pressure is being
applied to the trigger, and material is being
released from the gun at an increased rate.
TEXTURE TABLE
TEXTURE
Acoustic
Heavy Splatter
Medium Splatter
Orange Peel
Light Splatter
BEFORE SPRAYING
1. Use tape and heavy canvas drop cloths to protect areas you don't want sprayed. Thin plastic
drop cloths will not provide adequate protection.
2. Do not spray 100% vertically or you will lose efficiency.
3. Plan your path and ensure you have mixed enough material before you begin to avoid
disruption of your work.
4. You should always spray test an old piece of plywood or cardboard before you begin.
5. Always make sure you wear the proper safety equipment when using this item
TRIGGER
PRESSURE
PULL
16-21
Completely
11-16
Completely
16-21
Two-Thirds
19-24
One-Half
22-26
One-Third
3
THICKNESS
Product Directions
Thin
Thick
Thick
Thick
9
OPENING
8 mm
8 mm
6 mm
6 mm
4.5 mm