Poulan Pro HDF900 Manuel De L'opérateur page 5

Table des Matières

Publicité

UNPACK CARTON & INSTALL HANDLE
See Fig. 2)
CAUTION: Be careful of exposed sta ples
when handling or disposing of carton-
ing material.
IMPORTANT: WHEN UNPACKING AND AS SEM BLING TILLER,
BE CAREFUL NOT TO STRETCH OR KINK CABLE(S).
Cut cable ties securing handles.
The handle may be assembled in high or low posi-
tion. Slowly lift handle as sem bly up, route cable(s)
as shown and align han dle holes with desired handle
panel hole and slot.
Loosely assemble hardware as shown. Repeat for
opposite side. Tight en all hard ware se cure ly.
NOTE: Cables must not touch the muffler.
Cut cable ties securing tiller to skid and remove tiller
from skid.
Remove screws securing depth stake to skid and
discard the screws.
HAN DLE PANEL
NUT
CABLE
TILLER
HANDLE
HANDLE
PANEL
BOLTS
ASSEMBLY
TILLER
HANDLE
FLAT
LOCK
WASHERS
WASH ER
HEX BOLTS
5/16-18 x
Fig. 2
INSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
Loosen nut "A".
Insert stake support between engine bracket halves
with stake spring down.
Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten se curely. Tighten nut "A".
Depth stake must move freely. If it does not, loosen
support bolt.
1-1/4"
HANDLE HEIGHT
Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Ad just-
ments section of this manual).
TILLING WIDTH
Tilling width may be adjusted to better handle your
tilling con di tions (See "TINE ARRANGEMENT" in the
Ser vice and Adjustments section of this manual).
TINE OPERATION
Check tine operation before first use. (See "TINE
OPERATION CHECK" in the Service and Adjustments
section of this manual).
5
ENGINE BRACK ET HALVES
NUT "A"
DEPTH STAKE
SUPPORT
SUPPORT
BOLT
STAKE SPRING
HEX BOLTS,
LOCK WASH ERS, AND HEX NUTS
Fig. 3
DEPTH
STAKE

Publicité

Table des Matières
loading

Table des Matières