Table des Matières
Publicité
SERVICE AND ADJUSTMENTS
•
Recheck in "OFF" position and adjust if necessary.
FINAL CHECK "ON" POSITION
•
With tine control "ON" (held down to handle) push
down on handle to raise tines off the ground.
•
Slowly pull recoil starter handle while observing tines.
Tines should rotate forward.
•
If tines do not rotate, inner wire of control cable is too
loose. Loosen cable clip and pull cable up to remove
slack and retighten clip.
•
Recheck in "ON" position and adjust if necessary.
NOTE: If "ON" position check required adjustment, re-
check "OFF" position adjustment to insure tines do not
rotate when control is "OFF" (up).
FORWARD
TINE CONTROL
"OFF" (UP)
POSITION
TINE CON TROL CABLE
CABLE CLIP
TO REMOVE BELT GUARD (See Fig. 20)
•
Remove screws from side of belt guard.
•
Pull belt guard out and away from unit.
•
Replace belt guard by reversing above procedure. Be
sure slot in bottom of belt guard is under head of tine
shield bolt and all nuts are tightened securely.
FORWARD TINE
CONTROL
"ON" (DOWN)
POSITION
Fig. 19
SCREW
TO REPLACE V-BELT (See Fig. 21)
Replace V-belt if it has stretched considerably or if it has
cracks or frayed edges.
Belt guard must be removed to service belt. See "TO
REMOVE BELT GUARD" in this section of manual.
BELT REMOVAL
•
Remove V-belt from transmission pulley first and then
from engine pulley.
BELT REPLACEMENT
•
Install new V-belt to engine pulley first then to trans-
mis sion pulley. Be sure belt is positioned on inside
groove of both pulleys, inside all belt guides and rests
on idler pulley.
CHECK TINE OPERATION
•
See "TINE OPERATION CHECK" in this section of
manual.
REPLACE BELT GUARD
ENGINE
BELT GUIDE
PULLEY
BELT
GUIDE
14
BELT GUARD
Fig. 20
TRANS MIS SION PUL LEY
V-BELT
IDLER
PUL LEY
Fig. 21
SCREW
SCREW
Publicité
Table des Matières
