Table des Matières
Publicité
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Screwdriver
(1) Pair of pliers
(2) 1/2" wrenches
(6) Hex Bolts 5/16-18 x 1-1/4
ASSEMBLY
CONTENTS OF HARDWARE PACK
(1) Manual
(6) Lock Washers 5/16
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
LEFT
OPERATOR'S POSITION
(4) Washers 3/8 x 7/8 x 14
4
FRONT
RIGHT
Fig. 1
(6) Hex Nuts 5/16-18
Publicité
Table des Matières
