Extension Cords - POWER SMITH PAVC102 Manuel De L'opérateur

• Do not abuse the cord.
the cord to disconnect from power outlet. To unplug from power outlet, grasp the plug, not the cord.
• Keep cord away from heated surfaces, oil and sharp edges.
doors on the cord or pull around corners with sharp edges.
• Cords can become trip hazards. Do not leave the cord lying on floor.
Pick up the cord when you have completed cleaning work.
• Do not leave the vacuum plugged in when unattended or not in use.
Unplug from power source when not in use and before servicing.
• Do not drive or run over the cord.
• Do not use with damaged cord, plug or other parts.
functioning as it should, or has been dropped, damaged, left outdoors, or dropped in water, take it to
a service center.
• Do not use the Ash Vacuum with a torn filter
• Turn off the Ash Vacuum before unplugging.
• Unplug the Ash Vacuum from the power source before changing or
cleaning the filter
• Do not place, drop or insert any object into ventilation openings.
operate the vacuum with any ventilation openings blocked; keep free of dust, lint, hair or anything
else that may reduce airflow.
• Do not store the vacuum immediately
area or enclosed space. Allow the motor to cool and remove ash from canister before storage
• When using as a blower
- Direct air discharge only at work area.
- Keep children away when blowing.
- Do not direct air at bystanders.
- Do not use blower for any job except blowing dirt and debris.
- Do not use blower as a sprayer.
- Wear safety eye wear.
- For dusty operations, wear a dust mask.
FIRE HAZARD WARNING
• The Ash Vacuum is intended for vacuuming cold or warm ashes only.
Using the vacuum as a shop vacuum or for general household use could increase the risk of fire by
depositing combustible material into the canister prior to vacuuming ashes.
• Use caution when vacuuming materials that appear to have cooled,
but may actually still be hot inside.
ash to ignite again. As you vacuum, constantly check the nozzle, hose, canister, filter and motor for
excessive temperatures. If you notice an increase in temperature, turn off the vacuum immediately.
Unplug the vacuum and remove the vacuumed material from the canister and filter bag. Allow the
vacuum and the material to be vacuumed to cool before continuing to vacuum.

EXTENSION CORDS

Double insulated equipment can use either a two or three wire extension cord. As the distance from
the power supply outlet increases, you must use a heavier gauge extension cord. Using extension
cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and
possible tool damage. Refer to the table shown below to determine the required minimum wire size.
English
Never carry or pull the vacuum by the cord, use as a handle or pull
to reduce the risk of injury from accidental starting.
3
or without the filter installed
after ash removal or other use in a confined
Airflow created during vacuuming may cause hot
Do not close
If vacuum is not
.
Do not
.