Before Machine Start-Up - Nilfisk Alto SCRUBTEC 337 Manuel D'utilisation

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
NOTE
Install either the brush (A, Fig. 1) or the pad-holder (B and C) according to the type of floor to be cleaned.
1. Lift the brush/pad-holder deck (12) by prying the handlebar (1).
2. Place the brush (A, Fig. 1) or the pad-holder (B and C) under the deck (12).
3. Lower the deck (12) by using the handlebar (1).
4. Turn the knob (32) on one of the indicated programs.
5. Press the enabling push-button (39) together with the brush levers (40) to engage the brush/pad-holder.
To remove the brush/pad-holder, perform the following procedures.
6. Switch off the machine by turning the knob (32) to "0".
7. Slightly lift the machine deck by prying the handlebar (1), then manually release the brush/pad-holder from the hub, by turning
it abruptly in its normal rotation direction (D, Fig. 1).
A
Available brushes and their relevant application guides (suggestions only)
Models
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Solution tank filling
8. Open the filler neck (21), fill the tank (22) with a solution suitable for the work to be performed. Do not fill the solution tank
completely, leave a few centimetres from the edge. Always follow the dilution instructions on the label of the chemical product
used to prepare the solution. The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
Adjustments
9. Adjust the handlebar (1) with the lever (2) to reach a comfortable position.
9099222000
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
B
C
D
Front
Figure 1
MIDLITE GRIT 180 MIDGRIT 240
SCRUBTEC 337
ENGLISH
D
P100407
PROLITE UNION MIX
11