Inserting A Memory Card; Using The Remote Control - AgfaPhoto AF 5086MS Guide D'utilisation

Inserting a Memory Card

1 Switch the device off using the on/off switch on the
rear.
2 Insert a memory card into the appropriate card slot at
the rear of the device. Your photo frame supports the
following memory cards: SD/SDHC/MMC/MS/XD/
CF.
Only use storage media that are compatible with
the device. In order to prevent damage to the
card or the unit, please turn off the power before
removing or inserting the card.
Never pull out the memory card while the device
is accessing it. This could cause data to be dam-
aged or lost.
3 Switch the device on using the on/off switch on the
rear. The player will start slide show after the start
screen be displayed. Press F on the remote control to
stop the slide show.
Installing or Changing the Batter-
ies of the Remote Control
CAUTION! RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
1 Take the battery compartment from the remote control
by opening the locking mechanism (1) and pulling
out the battery compartment (2).
Initial Operation
2 Insert the new batteries into the battery compartment
with the positive and negative poles as shown on the
back of the remote control. Make sure the polarities(+
and -) are aligned correctly.
3 Push the battery compartment back into the remote
control until the locking mechanism engages.
Normally the batteries will last for around one year.
If the remote control does not work, please replace
the batteries. If the player is not used for a long time,
take out the batteries. So you can prevent leakage and
possible damage to the remote control.
The batteries used should be disposed of according to
the recycling regulations of your country.

Using the Remote Control

Point the remote control to the remote sensor on the front
panel of the device. Its working limits is within an angle of
30 degrees and a distance of 2 meter. When using the re-
mote control, no obstacle should be placed between the re-
mote control and remote sensor.
EN
7