End Panel Layouts - Orion HCCA10002 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27

END PANEL LAYOUTS

HCCA10002
1
2
ESP
INPUT
L CH
HCCA10004
1
7
8
GAIN
LF
RANGE
HIGH
ESP
LOW
RF
1.
ESP - Allows connection of a MD Audio Engineering ESP
controller, like the
Bitwriter.
2012 MD Audio Engineering. All rights reserved.
3
4
5
6
REMOTE
GAIN
L
R
L
R
INPUT
OUTPUT
OUTPUT
R CH
BRIDGE 4 OHM
9
4
10
11
12 13
LF
L
LR
CH
LINE REMOTE
INPUT
OUTPUT
INPUT
LR
MODE OUT
GAIN
2 CH
F/R SUM
4 CH
PASS
RR
RF
R
RR
2.
Speakers (Left channel) -Connect the speakers to these terminals.
(HCCA10002 only, refer to the Speaker Connections section of
this guide.)
Figure 1
3.
Input - Accepts RCA input from a head unit, preamplifier, or
Figura 1
equalizer (HCCA10002 only).
Abbildung 1
4.
RCA Line Output - Provides easy connection to additional ampli-
fiers, the RCA inputs and RCA output are the same signal and are
not affected by any amplifier functions.
5.
Speakers (right channel) - HCCA10002 only see item 2
6.
Remote Gain Input - Connects optional RGC2 remote gain control
to control the gain level from the driver's seat.
7.
GAIN RANGE - Selects the input sensitivity range to either High
(for high power head units) or Low (for line level head units).
8.
Speakers (Left Front and Right Front below) -Connect the speak-
6
ers to these terminals. (HCCA10004 only, refer to the Speaker
Connections section of this guide.)
9.
Input (Left Front and Right Front below) - Accepts RCA input from
a head unit, preamplifier, or equalizer (HCCA10004 only).
10.
Input (Left Rear and Right Rear below) - see item 9
11.
Speakers (Right Rear and Left Rear below) -see item 8
Figure 2
12.
2/4 Channel Switch - 2ch setting will allow 4 channel output with
Figura 2
a signal only present on the front inputs. 4 ch will allow a 4 chan-
Abbildung 2
nel output when signal is present on the front and rear inputs.
13.
Front/Rear Sum Switch - Allows you to sum the front and rear
channels together before sending the signal out the RCA line out.
If the switch is not engaged, then only the front left and front
right signals are sent to the RCA line out.
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hcca10004

Table des Matières