Orion HCCA10002 Mode D'emploi page 26

an event, the priority of the amplifier is given to continually checking
its health. Attempts to Write to the amplifier during and immediately
following an event may result in communication errors.
Except for overcurrent/short, the amplifier should clear any faults
when the condition that causes them clears. Substantial changes to
the amplifier parameters via the bitwriter may result in the audio
being interrupted momentarily. Also, the amplifier is designed to
fade up from protection events and when turned on.
NOTE: The amplifier can be reset by removing power to the main
battery terminals and keeping the remote line off for at least 30
seconds.
The major and minor revision levels of the ESP2 software should be
referenced should it be necessary to contact MD Audio Engineering or
Orion.
2012 MD Audio Engineering. All rights reserved. 24