Speaker Connections Hcca10002 - Orion HCCA10002 Mode D'emploi

3PEAKER#ONNECTIONS(##!10002
The Orion HCCA10002 amplifier offer one positive and one negative
output terminal for ease of connecting channel 1(L CH) and/or 2(R CH)
outputs to the speakers. The amplifier is stable to 2Ω per channel. See
diagrams below.
One Channel/Two Channel Configuration
s Lowest recommended impedance is 2Ω stereo.
s Outputs can be configured for high-pass, low-pass, or full range
operation.
L CH
Figure 14
Figura 14
Abbildung 14
Bridge Configuration
Bridging allows one speaker to be driven at a higher power level from
the amplifier.
s The bridged outputs lowest recommended impedance is 4Ω.
L CH
Figure 15
Figura 15
Abbildung 15
2012 MD Audio Engineering. All rights reserved.
R CH
R CH
Three Channel (L Channel, R Channel, Bridged)
s Left and Right are configured for two-channel stereo operation.
s Lowest recommended impedance is 2Ω stereo.
s The third output is configured for a single channel bridged out-
put.
s The bridged outputs lowest recommended impedance is 4Ω.
s Outputs are configured for high-pass, low-pass, or full range
operation.
L CH
Figure 16
Figura 16
Abbildung 16
NOTE: To get full output in this configuration, band limiting filters as
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.
R CH
12