Check For Leaks - Outdoor Leisure SPC-54PHW Manuel Du Propriétaire

aSSEMBLy InSTruCTIOnS
Continued
bURNER ANd CONTROL
ASSEMbLY
The connection between the fuel line to the
burner is a quick connect connection type.
Follow these steps to assemble, while refer-
ring to Figure 5.
1. Pull manifold out of top end of pole.
2. Slide/move quick connect collar of mani-
fold to the back.
3. Attach manifold to burner and control
assembly by pushing burner and control
assembly connection all the way through
manifold.
4. Make sure manifold and burner assembly
snap in properly.
5. Release the quick connect collar of mani-
fold that was slid to the back in step .
6. Place burner and control assembly onto
pole.
Burner and
Control
Assembly
Figure 5 - Connecting Manifold Assembly
to Burner and Control Assembly
6

ChECK FOR LEAKS

IMPORTANT: The heater must be leak tested
before any further assembly is done. Use
only a soap and water solution. DO NOT
USE FLAME.
Turn control knob to the OFF position. Se-
curely connect regulator to propane/LP gas
cylinder. Open propane/LP cylinder valve. Ap-
ply a soap and water solution to connections
at the manifold, burner, and control assembly.
Bubbles forming show a leak. In case of any
leaks, turn off propane/LP cylinder valve, re-
move manifold, check and clean connection.
Reconnect manifold and leak test again.
Upon completion of leak test, and when
there is no sign of a leak, turn off propane/LP
cylinder valve and disconnect regulator from
propane/LP gas cylinder. Remove propane/LP
gas cylinder and continue to next step.
POLE ANd bURNER/CONTROL
ASSEMbLY
Attach pole to burner and control assembly
(see Figure 6). Align the three holes. Insert a
small bolt in each hole and tighten using #
Phillips head screwdriver.
Manifold
Assembly
Pole
Figure 6 - Attach Burner and Control
www.desatech.com
Assembly to Pole
114144-01J