Outdoor Leisure SPC-54PHW Manuel Du Propriétaire page 5

aSSEMBLy InSTruCTIOnS
Continued
4. Insert manifold into pole support (see
Figure 2). Insert the manifold assembly
through the post by passing through the
hole in the post support. Note: Make sure
hose and regulator assembly attached to
manifold are never bent or kinked during
installation and operation of heater.
5. Attach pole to pole support (Figure 3).
Place pole into pole support center connec-
tor. Tighten six set screws with hex allen
wrench supplied with heater. Note: Set
screws are threaded inside post support.
6. Put propane/LP cylinder cover on base
assembly (see Figure 4). Slide propane/
LP cylinder cover over pole and pole sup-
port. Be sure that the propane/LP cylinder
cover rests level on the base.
Pole
Support
Legs
Base
Ballast
Weight
Figure 1 - Base Assembly
114144-01J
Pole
Support
Figure 2 - Installing Manifold Assembly
Pole
Pole
Support
Figure 3 - Pole to Pole Support
Propane/LP
Cylinder
Cover
Base
Figure 4 - Propane/LP Cylinder Cover
www.desatech.com
Pole
Manifold
Assembly
5