Light Bulb Replacement - Heat Surge Fireless Flame Original Roll-n-Glow Manuel

LIGhT bULb REPLACEmENT

light bulbs need to be replaced when you notice a dark section lacking detail in the flame and log set.
Allow at least 5 minutes for light bulbs to cool off before touching to avoid burning of skin.
bULb REQUIREmENTS
Quantity (2) clear chandelier or candelabra bulbs with an e-12 (small) socket base, bulb rating of 40 watts for 120 volt
electrical service.
CAUTION: Do not exceed 40 watts per bulb.
ChANGING LIGhT bULbS
1. Unplug the power cord.
2. remove the lower light bulb access panel by removing the panel screw on the left and right sides.
3. examine the (2) 40 watt bulbs to determine which bulb requires replacement.
4. These bulbs ship from the amish facility with a tension clip on them. This wire prevents the bulbs from vibrating loose
during shipping. You can remove these clips during the first light bulb change or leave them in place. *note: removing
these clips will not affect the function of the fireplace.
5. remove the old bulb by gripping the socket base with one hand and turning the bulb counter-clockwise (left) with the
other. install a new 40 watt bulb into the socket.
6. To finish up replace the light bulb access panel and reinstall the two panel screws.
CLEANING
CLEANING AND mAINTAINING ThE WOOD mANTLE
The amish made fireplace mantle will retain its beauty for many years with a few simple steps.
CleaninG: it is ok to wipe down the mantle with a water dampened cloth and mild soap. refrain from using strong or
abrasive cleansers.
POliSHinG: restore the mantle's finish using wood polish or oil and a clean soft cloth.
CLEANING AND mAINTAINING ThE hEATING INSERT
The heating insert can be cleaned and maintained by following the simple steps listed here:
CleaninG THe HOUSinG: it is ok to wipe down the heating insert with a water dampened cloth and mild soap. refrain
from using strong or abrasive cleansers.
CleaninG THe GlaSS: a retail glass cleaner and a non-abrasive cloth should be used to clean all glass surfaces.
7
(some models)