Brandson 303503 Mode D'emploi page 45

Now mount the wheels on the shaft and slide it in.
Then connect the switch cable.
4
To adjust the length of the telescopic handle, release the clamping
mechanism for the telescopic handle (7) and adjust the handle to the
desired length. Then tighten the clamp again.
Press thebracket button (6) to rotate the tool to the left or right and use
it as an edge trimmer. Ensure that it snaps into place!
To remove proceed in the reverse order.
To remove the bracket (4), press the racket button and then pull the
b
bracket.
Important! Never remove or bypass the switches mounted on the tool
by the manufacturer (e.g. by attaching a button to the handle), as this
would prevent the tool from switching off automatically and would pose
a high risk of injury. Do not use the hedge trimming blade with the tele-
scopic handle.
45
English