EGO POWER+ SNT2110 Guide D'utilisation page 23

POWER INDICATOR MEANING
Shining green
Shining red
Flashing red
Shining orange
Flashing orange
SNOW BLOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too much snow at one time. Slow
down your pace or decrease the width of the snow-clearing swath.
Your snow blower has built-in overload-sensing elements. When the snow blower is
overloaded, the motor will decrease the speed automatically and you will hear the
volume of the motor decrease. Slow down your pace or narrow the clearing width in
this case, after which the motor speed will resume its normal setting automatically. If
this remedy does not solve the overload situation, the sensor will shut off the motor
automatically and the power indicator will blink orange. Remove the battery pack(s)
from the snow blower. Check to see if there is snow or ice stuck in the auger and deck,
and use a clean-out tool to clear them out as necessary. Reinstall the batteries and
restart the snow blower.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC
Snow blower is working
properly; each battery has
at least 15% of its charge.
Battery pack(s) charge
level is low.
The battery pack is nearly
depleted.
The snow blower
or a battery pack is
overheated.
The snow blower is
overloaded.
ACTION
n/a
Stop the snow blower and
charge the battery pack(s).
Stop the snow blower and
charge the battery pack(s).
Stop the snow blower and
wait for some time to cool the
machine or the battery pack(s).
Remove the battery pack(s),
check and clean if snow has
collected beneath the deck or is
lodged in the auger. Slow down
your pace or decrease the snow
clearing cut width when working.
23