EGO POWER+ SNT2110 Guide D'utilisation page 19

WARNING:
blower is turned off. Allow the auger to stop rotating before starting it again.
NOTICE:
Do not rapidly turn the snow blower off and on.
To Start the Snow Blower
1. Ensure that the side rails are
securely locked in the unfolded,
open position.
2. Attach the battery pack(s) to the
snow blower and close the battery
cover.
NOTICE:
Make sure that the latch on the
snow blower snaps into place and that the
battery pack(s) are secured to the snow
blower before operation.
3. Depress the safety button and, with
the button depressed, pull the bail
switch upward to meet the handle
(Fig. 13 &14).
4. Once the tool powers on, release the
safety button and begin operation
(Fig. 15).
NOTICE:
The tool is started by
depressing the safety button first,
followed by squeezing the bail switch; the
reverse operation will not start the tool.
NOTICE:
The snow blower may not
properly start if its battery temperature
is -4°F (-20°C) or less. If unit doesn't
start, remove the battery from the snow
blower and allow it to warm indoors for
10 minutes or longer. Reinstall the battery and try again.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC
The auger will continue to rotate for a few seconds after the snow
13
1
14
15
2
2
1
19