Commissioning And Operation; Auto Mode; Continuous Mode - Klarstein DRYFY CONNECT Serie Mode D'emploi

EN

COMMISSIONING AND OPERATION

Timer (set time to automatically switch off)
When the dehumidifier is in operation, press the TIMER key to adjust the time from 1
h - 24 h. If you press the button once, the time is set to 1 hour. Pressing the button several
times increases the time by one hour. If you press the button again after 24 hours,
the time starts at 1 again. If the time you set has elapsed, the appliance switches off
automatically. If no button is pressed within 5 seconds after the setting is completed, the
set time to switch off is confirmed. When the auto power off time has been set, the timer
indicator light will usually illuminate.
Timer (Setting the Time to Auto Power On)
When the unit is in standby mode, the auto power on time can be set in the same way
as the auto power off time (see above). If no button is pressed within 5 seconds after
the setting is completed, the set time to power on is confirmed. When the auto power on
time has been set, the timer indicator light will usually light up.

AUTO Mode

If you select the automatic mode, the compressor and fan will run if the indoor humidity
is higher than 5% higher than the set target humidity. If the indoor humidity is less than
5% higher or lower than the target humidity, the compressor and fan will continue to run
at the set speed. If the indoor humidity is more than 5% lower than the target humidity,
the compressor shuts down, but the fan continues to run at the set speed. The factory-set
humidity value is 50%.

CONTINUOUS mode

If you select this mode, the compressor will start regardless of relative humidity. The
factory setting is for the fan to run at maximum speed in this mode. The speed of the air
circulation can be adjusted using the speed button.
30