Troubleshooting - Nesco American Harvest VS-09HH Guide D'entretien Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The charger does not charge:
Check whether the indicator LED light is on. If not, make sure if the charger and
the outlet has been connected properly. If yes, try a new electrical outlet.
If the charger does not charge when indicator LED light is on, check if the charger
and vacuum sealer are seated properly, adjust if needed.
It stops working soon after charged.
Make sure if the indicator LED lights are on during charging, if not, check if the
vacuum sealer and charger are in good contact.
If the indicateor LED lights are on during charging, make sure if the charging time
is sufficient. Indicator LED light will turn green when fully charged.
Please contact NESCO customer support 1-800-288-4545 if it still does not work.
Air is not removed from the bag completely.
Bags are not sealed, reseal the zipper, and then slip the entire zipper with your
finger.
Replace the zip bag and make sure the valve is clean.
The items are blocking the valve, position so valve is open or there is too much
stuff inside bag.
Extend the vacuuming time and press most of air out before sealing zipper.
The canister will not vacuum:
Make sure the adaptor was well connected to both the vacuum sealer and the
canister.
Check if the button of the canister was on the position of "seal".
Press the lid downward at the very beginning of vacuuming. This will help to seal
canister and lid.
Check if there is any damage to lid or canister, if yes, do not use.
Check the function of the vacuum sealer to be sure iti is pulling a vacuum.
Check if the outer suction has been deformed, fractured or blocked, if yes, change
it for a new one.

Troubleshooting

7

Publicité

Table des Matières
loading

Table des Matières