Skytec 154.083 Mode D'emploi page 7

Keep the PROG SELECT button pushed in and press the STAND BY button until the indication St is
displayed. Release both buttons. Then press the PROG SELECT button in order to browse manually
through the programmed steps (scenes).
Memory position AP (automatic play)
Keep the PROG SELECT button pushed in and press the STAND BY button until the indication AP is
displayed. The stored steps (scenes) are now played through automatically. You can set the speed via
the SPEED slider control or the TAP SYNC button. The slider controls CH1 to CH4 and DIMMER are
de-activated.
Memory position AS (automatic play with music control)
Keep the PROG SELECT button pushed in and press the STAND BY button until the indication AS is
displayed. You can now play your self-programmed steps which are controlled via an internal or
external audio signal. The SPEED control and the TAP SYNC push button are switched off.
Specifications
Power supply 230 V/ 50Hz
Max. load per channel 1000W (230V/5A)
Max. total load 3300W (230V/16A)
Number of channels
Number of programs
Audio input signal
Music-controlled
Dimensions (hxwxd)
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the
warnings contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations
and warnings. This is also applicable to all damages in whatever form.
___________________________________________________________________
4
2 and 7 operation modes
100 – 1000mV
Vie built-in microphone or external audio signal
132 x 483 x 150 mm, rack mountable