Skytec 154.083 Mode D'emploi page 5

General Safety Recommendations:
- Read the instruction manual thoroughly prior to using the unit.
- Keep this manual for future reference.
- Keep the packaging so that the unit can be shipped in the original packaging in order to avoid
damage.
- For indoor use only.
- Make sure that there is sufficient cooling in the mounting area.
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a
mains outlet.
- Keep away from heat and direct sunlight. Make sure that neither liquids, nor small objects can
enter the unit through the ventilation holes.
- Only clean the unit with a damp, dust free cloth. Do not use cleaners or solvents!
- Do not use contact spray or cleaning agent to clean the switches and pot meters.
- Repairs have to be carried out by a qualified technician only.
- Only connect this unit to an earthed mains outlet of 230Vac/50Hz and 10-16A.
- Always unplug the unit during a thunderstorm or when it is not in use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- The unit does not contain any user replaceable parts other than those specified in this manual.
- In order to avoid accidents in public premises, the local legal requirements and safety
regulations/warnings must be fulfilled.
- Keep out of the reach of children.
General Description
This compact DMX light controller features a built-in dimmer pack and can control up to 4 DMX
channels. The controller offers 7 different operation modes and has a pre-programmed memory for 42
running light programs. Moreover the user can store his own program of 32 steps max. (scenes) into
the memory. This program can be altered any time. The connected light effects can be music
controlled via an external audio source or the built-in microphone.
Connections
Connect the controller to a mains outlet via the earthed mains lead. Connect the lamps or groups of
lamps. Only use earthed leads.
Control functions
Slider controls CH 1 to CH 4 are used to set the light output levels.
Push buttons FLASH Push to increase the lamps or group of lamps to full intensity
Push button MODE SELECT is used to select one of the 7 operation modes
Push button PROG SELECT is used to select one of the 42 preset light programs
Push button STAND-BY Push this button to set all outputs to zero.
Push button FULL ON Push this button to set all outputs to 100%
Push button TAP SYNC By tapping on this button to the beat of the music, the step speed will be
synchronized with the music.
Slider control FADE TIME controls the speed setting of the light intensity
Slider control AUDIO sets the sensitivity of the built-in microphone and the audio input.
Slider control SPEED sets the step speed of the running light effect units
Setting of the audio source for music-control
You can chose between the control by an external audio signal or via the built-in microphone. The
setting is made as follows: Switch the controller off via the ON/OFF switch on the top left side of the
panel. Hold the PROG SELECT button pushed in and switch the controller on again. Push the button