Installation For Units Equipped With Casters; Cabinet Bases; Assembly Of Broiler; Ventilation - Garland G-BRL Serie Manuel D'installation Et D'utilisation

INSTALLATION continued

Installation for Units Equipped with Casters

A . The installation shall be made with a connector that
complies with the Standard for Connectors for Moveable
Gas Appliances, ANSI Z21 .69/CSA 6 .16, Addenda
Z21 .69B-2006/CSA 6 .16B-2006 (or latest edition), and a
quick-disconnect device that complies with the Standard
for Quick Disconnects for Use with Gas Fuel, ANSI Z21 .41/
CSA 6 .9, Addenda Z21 .41A-2005/CSA 6 .16A-2005 (or latest
edition) .
B . Raise the front of the appliance and block . Do not lay the
appliance on its back .
C . Caster are threaded to be easily screwed into the holes
provided on the bottom of the range . It is important to
add the washers supplied to help distribute force on the
range when being moved .
PROTECTIVE
BOTTOM
PLASTIC ON
OF
THIS SIDE
APPLIANCE
FIXED CASTER
(SHOWN W/O BRAKE)
D . Place the washer on the caster stem as shown . Since
the washer is slightly cupped, it is critical that the side
with the plastic is up and mates with the bottom of the
appliance . With the washer in place, thread the caster
onto the appliance tightly . It is not necessary to remove
the plastic from the washer .
E . The front casters of the unit are equipped with brakes
to limit the movement of the unit without depending
on the connector and any quick-disconnect device or its
associated piping to limit the appliance movement .
F . Please be aware, there is a restraint on the unit and if
disconnection of the restraint is necessary, be sure to
reconnect the restraint after the unit has been returned
to its originally installed position .

Cabinet Bases

Cabinet base options are available for all broiler models .
Cabinets are pre-assembled at time of delivery except legs or
casters .
Page 10
WASHER BOTTOM
APPLIANCE
ADJUSTABLE CASTER
(SHOWN W/O BRAKE)

Assembly Of Broiler

Steel Grate Rods
Each broiler is supplied with (14) 15"/381mm, (18-BRL),
21"/533mm, (24-BRL), 26" /660mm, (30-BRL), 31"/787mm,
(36-BRL) or 2 sets of 21"/533mm (48-BRL) long steel rods .
These rods are to be installed in the grooves on the support
brackets, which are atop the burners .
Briquettes
For best cooking results, it is recommended that the correct
amount of briquettes are installed in the broiler . Refer to
the table and drawing below for the proper arrangement
of briquettes . When all the briquettes have been placed as
instructed, install the top grate sections .
MODEL
Rows
front
to rear
OF
Rows
left
to right

Ventilation

The following notes are intended to give general guidance .
For detailed recommendations, refer to the applicable
code(s) in the country of destination .These appliances shall
be installed in a room with sufficient ventilation to prevent
the occurrence of hazardous concentrations of combustion
by-products .
A good ventilation system is important for satisfactory
performance and it is recommended to install the broiler
under a power vented canopy .
Local and/or National Codes dictate the need of ventilation
system to be used with this type of equipment . The following
information is provided to give examples of available
ventilation system concepts .
18-BRL 24-BRL 30-BRL 36-BRL 48-BRL
7 7 7
7 11 14
Part # 4525958 (05/15/09)
7 7
17 22