Setup; Unfolding The Handle; Installing The Discharge Chute - Poulan Pro PR111 Manuel Du Propriétaire

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
1.
No parts required
2.
Carriage bolts
Shoulder Bolt
Flange nuts
Washer
Knob
Cap Plunger
Chute
Deflector

1. Unfolding the Handle

Procedure
1. Loosen the two handle knobs and pull out the two
handle bolts until you can move the handle freely and
rotate the handle to the operating position (Figure 2).
1
2
1. Handle knobs
2. Tighten the handle knobs until they are snug (Figure 3).
Qty.
–
4
1
4
1
1
1
1
1
Figure 2
2. Handle bolt
Figure 3
Use
Unfold the handle.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.
Install the discharge chute.

2. Installing the Discharge Chute

Procedure
1. Install the chute deflector to the discharge chute using
bolts and, washer, nut, deflector knob and cap plunger
(Figure 4).
2. Install the discharge chute to the chute base using
three screws and nuts.
8
7
4
5
10
3
1. Deflector
2. Carriage bolts
3. Flange nuts 5/16-18
4. Washer
5. Knob
IMPORTANT: Do not overtighten the flange nuts; other-
wise you may damage the discharge chute.
5
Tools Required
–
1/2" Wrench
7/16" Wrench
3/8" Wrench
9
1
6
3
2
2
Figure 4
6. Discharge chute
7. Carriage Bolt
8. Shoulder Bolt
9. Flange nuts 1/4-20
10. Cap Plunger