Genie LA 402 Mode D'emploi page 7

Starting up the laminating machine
1. Push the plug into the mains socket outlet and set the switch to 'I'. The red
LED (Power) lights up and the heating process will begin.
2. The green LED (Ready) lights up after approximately 3 - 5 minutes. Now you
can begin the laminating process.
3. Open the laminating film and lay the material that is to be laminated directly
onto the closed side. Leave a margin of between 3 mm and 5 mm
approximately beyond the edges while doing so.
Caution
a) Choose a film of correspondingly suitable size in relation to the material that is to
be laminated respectively.
b) It is not recommended to process several smaller materials in one film.
c) Do not cut up the film before the laminating is done.
d) The material that is to be laminated, is not allowed to be thicker than 0.5 mm
including the film.
e) It is imperative to only laminate very thin or soft materials, like newspaper or
serviettes for example, with thicker films (100 microns). We recommend refraining
from any attempt to do so!
f) Do not insert any laminating film without the contents.
g) Never utilize laminating pockets on one side or when they are rolled up.
h) Only utilize laminating foils that are also described as such. Other kinds of film, like
transparent wallets for example, are unsuitable for laminating!
4. Insert the material within the laminating film straight and with the closed side
first into the feed opening on the machine's front side. The material will feed it
in automatically now.
5. The laminated material that emerges from the delivery opening on the
machine's back side is not allowed to be pulled out by force. Wait until it has
run out of the machine completely. Let the laminated material to cool down
briefly!
6. Switch off the machine after the laminating has ended, by setting the switch to
'O'. Let the machine cool down and always pull the plug out of the mains
socket outlet after using the machine.
Note: Do not feed the laminator further with foil in case of a blockage. Turn off
the device immediately!
7