Genie LA 402 Mode D'emploi page 6

(GB) Operating Instruction
Dear customer,
thank you for buying this quality product from GENIE. Please read this instruction
carefully before initial operation. Particularly take note of the following safety
instructions. Please keep this instruction for future reference and pass it, when
handing over this item. If you should have any further questions on the device or
complaints you will find our service information at the end of this instruction.
Intended Use:
The laminator is only suitable for laminating documents. Any other use or
modification shall be deemed to be improper and involves substantial risk of
accidents.
Important advice about safety
1. Read through these operating instructions carefully and completely before using
the machine for the first time.
2. Only put the machine on a flat and dry surface. It must be freely accessible from
all sides. It is not recommended to use an extension cable!
3. Do not open or repair the laminating machine yourself but take it to your
specialized dealer whenever it is damaged, or contact our service hot line.
4. Only use films of the correct size (up to DIN A4 max.) and thickness (80 to 100
microns). Films that are too thin cause a blockage of the film in the machine.
5. Do not touch the hot surface of the machine after it has started up.
6. The laminating machine is not allowed – for safety reasons – to be used by
children, unless they are supervised by an adult.
7. Never use the machine outdoor or near water.
8. Hot lamination: do not laminate in this mode any materials that are sensitive to
heat with this machine, like thermo-fax paper for example. These materials are
only suitable for cold lamination.
9. Do not pour or spill any liquid into the machine or onto it.
10. Do not insert any metal objects into the machine. Please do not grasp inside the
machine with your fingers.
11. The laminating machine is unsuitable for constant use commercially. It is
recommended to switch „O" the machine for 30 minutes, after it has been
operating for a period of approximately 30 minutes.
12. The socket should be near the device and easily accessible.
6