Usage - Beurer Barbers Corner HR 6000 Mode D'emploi

1. Ensure that the device is switched off be-
fore charging the battery.
2. Connect the mains adapter to a suitab-
le socket.
3. Plug the other end of the mains adapter
into the connection socket
on the underside of the de-
vice. The charge indicator
now begins to flash. The
battery indicator shows you
the current battery state in
percent. As soon as the
battery is fully charged, the charging in-
dicator goes out.
4. Once the charging process is complete,
pull the mains adapter out of the socket
and the device.
Quick charging
If you have forgotten to charge the shaver
before use, the quick-charge function helps.
Connect the device to the power supply for
this purpose. The device will be ready for
a complete shave using battery operation
within 5 minutes.
Mains operation
To operate the device with the supplied
mains adapter, proceed as follows:
1. Connect the mains adapter to a suitab-
le socket.
2. Plug the other end of the mains adapter
into the connection socket on the under-
side of the device. The battery indica-
tor shows you the current battery state
in percent and the charge indicator be-
gins to flash. The mains adapter supplies
enough energy to charge the battery and
operate the device at the same time.
3. After use, pull the mains adapter from the
socket and the device.
30
WARNING
Never use the device in the shower when it
is being operated via the mains.
The hand-held part of the Body groomer
must be disconnected from the connection
cable before use in a damp environment.

8. Usage

Travel lock
The device has a travel lock. If the travel
lock is activated, it is not possible to switch
on the device. The travel lock prevents the
device from switching on by accident (e.g.
when transporting it in a suitcase). To ac-
tivate the travel lock, press and hold the
ON/OFF switch for 3 seconds. The travel
lock indicator begins to flash. The device is
now locked. If the ON/OFF switch is briefly
pressed when the device is locked, the trav-
el lock indicator will light up in the display to
indicate that the device is locked. To deacti-
vate the travel lock, press and hold the ON/
OFF switch again for 3 seconds.
Direct drive function
If the battery is completely flat, you can
continue using the device immediately via
mains operation.
Tips before cutting/trimming hair
• Be particularly careful when using the de-
vice in areas with thin skin or skin creas-
es (e.g. armpits or pubic area) in order to
avoid injuries. Try to stretch the skin using
your fingers.
Cutting/trimming hair
You can either trim body hair with the
length-adjustable comb attachment or re-
move it entirely without the length-adjusta-
ble comb attachment.
31