Routine Maintenance - Uline SHOP VAC H-5814 Mode D'emploi

DAILY
1. Filter - Check cartridge filter for clogs or heavy
soiling and replace if necessary. Ensure that correct
filters are being used for the task – see Filters section
of instruction manual.
2. Collection Bag - If using collection filter bag, check
to ensure that there are no rips or tears in the bag
and that the bag is not full.
3. Tank – If vacuuming up wet or damp material,
empty the tank after use, as musty odors may occur
if debris is left inside.
4. Extension Cord and Plug – Check extension cord
and plug for any cuts or damage. If damaged,
replace motor housing unit.
5. Motor – If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately. Contact Uline Customer Service.
ISSUE
Parts/accessories missing
Vacuum cleaner will not start
Dust discharging from exhaust
Loss of suction
Static shock
PAGE 8 OF 24

ROUTINE MAINTENANCE

WEEKLY
1.
2. Hose – Inspect hose for any damage and replace if
MONTHLY
1. Cleaning – Inspect and clean all areas of the
TROUBLESHOOTING
POSSIBLE CAUSE(S)
1. Packed in tank
1. No power at receptacle
2. Defective switch
3. Defective motor
1. Filter not installed or installed improperly
2. Filter damaged
3. Filter clogged or dust is too fine
4. Filter not functional
1. Loose hose connection
2. Filter clogged
3. Full tank
4. Hole in hose
1. Dry environment
2. Relative humidity of air is low
1-800-295-5510
uline.com
Wands/Tools – Inspect wands and tool attachments
for any damage. Replace if necessary.
necessary.
vacuum, including the inside of the tank.
1. Check in tank
1. Check for power
2. Replace switch
3. Replace motor
1. Properly install filter
2. Replace filter
3. Use more efficient filter
4. Clean and replace filter
1. Tighten hose connection
2. Clean or replace filter
3. Empty tank
4. Replace hose
1. Add moisture to air (if practical, use a
console or installed humidifier)
2. This situation is temporary and does not
affect the use of the vacuum cleaner
CORRECTIVE ACTION
0521 IH-5814