Outdoor Leisure PGLHB36 Instructions D'assemblage page 3

9. Position lightpost panel assembly on top of burner assembly as
shown. Secure in place with 2 screws (C).
10. Position top assembly on top of lightpost panel assembly and
secure in place with 2 screws (C).
11. Attach back lightpost panel to burner assembly and top assembly
using 4 screws (C). Do not attach lightpost panels together at this
time.
Top Assembly
Lightpost Panel
12. Lay assembly on the floor as shown positioning rear of unit toward
the floor. Remove protective paper and plastic from hose and
regulator.
123222-01A
Burner
Assembly
13. Install 2 DD size batteries as shown.
Note: If needed, acquire assistance lifting assembly.
14. Place entire lightpost assembly on top of cabinet base assembly.
Do Not
Attach with 4 screws (C).
Attach
15. Install 2 screws (C) into holes on each side of control valve. Attach
control valve nut and control knob to control valve stem.
www.desatech.com
3