Cycle Setting Buttons; Custom Program - LG DLE2140 Serie Mode D'emploi

CYCLE SETTING BUTTONS

SENSOR DRY cycles have preset settings
that are selected automatically and cannot be
changed. MANUAL DRY cycles have default
settings, but you may also customize the settings
using the cycle setting buttons. Press the button
for that option to view and select other settings.
DRY LEvEL
Selects the level of dryness for the
cycle. Press the DRY LEVEL button
repeatedly to scroll through available
settings.
• This option is only available with SENSOR DRY
cycles.
• The dryer will automatically adjust the cycle
time. Selecting VERY DRY or MORE DRY will
increase the cycle time, while LESS DRY or
DAMP DRY will decrease the cycle time.
• Use a LESS DRY or DAMP DRY setting for
items that you wish to iron.

CUSTOM PROGRAM

If you have a special combination of
settings that you use frequently, you
can save these settings as a CUSTOM
PROGRAM.
To Save a Custom Program:
1 Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
2 Use the cycle setting buttons to adjust the
settings for that cycle.
3 Press the cycle option button(s) for the
option you would like to add. A confirmation
message will be shown in the display.
4
Press and hold the CUSTOM PROGRAM
button for 3 seconds.
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
30
NOTE: To protect your garments, not every
dryness level, temperature, or option is available
with every cycle. See the Cycle Guide for details.
TEMP. CONTROL
Adjusts the temperature setting from
ULTRA LOW to HIGH. This allows
precise care of your fabrics
and garments. Press the TEMP.
CONTROL button repeatedly to scroll through
available settings.
TIME DRY
Allows you to manually select the
drying time, from 20 to 60 minutes, in
10- minute increments. Use this for
small loads or to remove wrinkles. Use
the MORE TIME/LESS TIME buttons to add or
reduce the drying time in 1-minute increments.
SIGNAL
Adjusts the volume of the end-of-cycle
signal or turns off the signal.
To Recall a Custom Program:
Turn on the dryer.
1
Press the CUSTOM PROGRAM button.
2
Press the START/PAUSE button to start
3
the cycle.