Before First Use - AEG FFB53600ZM Notice D'utilisation

Not all options are
compatible with each other.
If you select non compatible
options, the appliance
automatically deactivates
one or more of them. Only
the indicators of the still
active options are on.
If an option is not applicable
to a programme, the related
indicator is off or it flashes
quickly for a few seconds
and then goes out.
Activating options can affect
the water and energy
consumption as well as the
programme duration.
7.1 XtraDry
Activate this option to boost the drying
performance. With XtraDry on, the
duration of some programmes, water
consumption and the last rinse
temperature can be affected.
XtraDry is a permanent option for all
programmes other than
need not to be selected at every cycle.
In the other programmes the setting of
XtraDry is permanent and it is
automatically used in next cycles. This

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
After starting a programme, it may take
up to 5 minutes for the appliance to
recharge the resin in the water softener.
configuration can be changed at any
time.
Activating XtraDry deactivates TimeSaver
and vice versa.
How to activate XtraDry
Press Option until the indicator
The display shows the updated
programme duration.
7.2 TimeSaver
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
and
How to activate TimeSaver
Press Option until the indicator
The display shows the updated
programme duration.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure is repeated periodically.
8.1 The salt container
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
Every time is
activated, XtraDry is off and
needs to be chosen
manually.
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
ENGLISH 35
is on.
is on.