Lutron DVCL-153P Guide D'installation Rapide

Quick Install Guide
How-to videos
l u t r o n . c o m / C L w i r i n g
DVCL-153P, DVWCL-153P,
SCL-153P, DVSCCL-153P,
LECL-153P, CTCL-153P
150 W 600 W *
LED / CFL Incand. / Halogen
DVCL-253P, DVSCCL-253P
600 W *
250 W
Incand. / Halogen
LED / CFL
Please read before installing
English
WARNING: SHOCK HAZARD. May result in serious injury or death.
Turn off power at circuit breaker or fuse before installing.
Single Pole
For lights switched from one location:
Green wire
NOTE: Black and solid red wire on the dimmer are interchangeable.
AFTER INSTALLATION: Adjust dimming range for LEDs and CFLs
1. Turn lights ON and move slider to bottom.
2. Adjust lever to improve dimming. NOTE: The Adjustment Lever on
your dimmer may be in a different location than shown.
3. Turn lights OFF and ON to verify proper operation.
For Troubleshooting, please visit www.lutron.com/support
Limited Warranty: www.lutron.com/TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf
Lutron and LED+ are trademarks or registered trademarks of Lutron Electronics Co., Inc., in the U.S. and other countries. The YouTube icon is a trademark of Google LLC.
Receive an Extended Warranty: www.lutron.com/CLregistration
Support: 1.844.LUTRON1 (USA / Canada)
LED + Dimmer
Install with
confidence
Use included diagrams
or visit our website for
step-by-step instructions.
Ganging and Derating
Remove side sections if mounting
two or more devices side by side
(see chart for new wattage rating).
* Maximum Allowable Inc. / Hal. Wattage
No sides 1 side removed
removed
600 W
Bend back
and forth
INSTALL WITH CONFIDENCE
VIDEO & STEP-BY-STEP INSTRUCTIONS VIDEO & STEP-BY-STEP INSTRUCTIONS
l u t r o n . c o m / C L w i r i n g
Use blue
connector
Insert
and twist
to tighten
Ground wire
(bare or green)
®
120 V~ 60 Hz
2 sides removed
500 W 400 W
For lights switched from two locations:
IMPORTANT: Mark or tag the common
wire before removing the old switch.
QUESTIONS? See lutron.com/CLwiring
OR
Green wire
NOTE: Only one dimmer can be used in a 3-way circuit.
©2013–2019 Lutron Electronics Co., Inc.
+ 1.888.235.2910 (Mexico)
P/N 0301917 REV A
Find the right LED
lutron.com/LEDfinder
Important Notes
1. CAUTION: Use only with permanently installed
fixtures with dimmable screw-in compact fluorescent,
dimmable screw-in LED, halogen, or incandescent
lamps. To avoid overheating and possible damage to
other equipment, do not use to control receptacles,
motor-driven appliances, or transformer-supplied
appliances.
2. Install in accordance with all national and local
electrical codes.
3. When no "grounding means" exists in wallbox, the
National Electrical Code (NEC ) allows a control to be
®
installed as a replacement when a plastic faceplate with
plastic fasteners is used, or the circuit is protected by a
ground fault circuit interrupter (GFCI). Lutron wallplates
meet this requirement. Cap or remove green wire before
screwing control into wallbox.
4. Protect the dimmer from dust and dirt when painting or
spackling the wall.
5. It is normal for the dimmer to feel warm to the touch
during operation.
6. Clean the dimmer with a soft damp cloth only. Do not
use any chemical cleaners.
7. For indoor use only.
3-Way
Tag
Insert
and twist
to tighten
Ground wire
(bare or green)
5