ARENDO 300792 Mode D'emploi page 13

4.4 Buttons
The following table provides an overview of the button functions:
• Changing the information displayed in Energy and Cost
SET
• Selecting the digit to be changed when setting the ener-
• Changing the information displayed at the Energy display
ENERGY • The overload limit can be adjusted by pressing it for 3
• Changing the information displayed at the Cost display
COST • The energy price can be adjusted by pressing it for 3
• Changing the selected digit when setting the energy
UP
• Resets the power cost monitor if the display is incorrect
RESET
5 Adjusting the overload limit and the energy price
Press and hold the ENERGY button for 3 seconds to adjust the overload limit. You
can select the digit to be changed using the SET button. Then press the UP button
till the desired value is reached.
To exit the configuration mode, press the ENERGY button briefly once again. If
the energy consumption exceeds the overload limit, then this is indicated by a
flashing "OVERLOAD" in the energy display.
Note: The energy cost meter is designed for a maximum power of 3680 watts. Do
not set the overload limit above this value and do not connect any devices whose
energy consumption is more than 3680 watts.
English
display
gy price or overload limit
seconds
seconds
price or overload limit
or if the meter does not respond to the pressing of
buttons
13