Worx WG284 Mode D'emploi page 13

Side cutting
WARNING: Stop operating the
trimmer before rotating the handle.
Lubricating the cutting blade
NOTE : It is important to use
only the recommended standard
lubricating oil (WD-40) to avoid
damage to the blade.
To store your hedge trimmer
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and
remove any foreign objects that could become
thrown or entangled in the blades. Always
hold the trimmer with both hands and with
the blade away from you before turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levers before
attempting to clear jammed debris from the
cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
Top cutting
Use a wide sweeping motion (See Fig. E1). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
Side cutting
When trimming the sides of the hedge, begin
at the bottom and cut upwards, tapering
the hedge inward at the top. This shape will
expose more of the hedge, resulting in a
more uniformed growth
BATTERY STATUS (See Fig. F )
Before starting or after use, press the button
beside the power indicator light on the
machine to check the battery capacity. The
Cordless Hedge Trimmer
indicator lights displays the battery condition
See Fig.
as follows:
K1, K2
Battery indicator
light status
See Fig. L
Five green lights
(
illuminated.
See Fig. M
Two, three or four
green lights are
illuminated.
Only one green
light (
illuminated.
No light is
illuminated.
Only one light is
flashing twice per
cycle.
Only one light
is flashing three
times per cycle.
Only one light is
flashing four times
per cycle.
MAINTENANCE
Remove the battery from Hedge
trimmer before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working
controls free of dust.
Battery condition
The two batteries are in a
) are
highly charged condition.
The two batteries have
a remaining charge.
The more lights are
illuminated, the more
battery capacity.
At least one battery is
) is depleted and needs to be
charged.
At least one battery is
not fully installed or
battery may be defective.
At least one battery is
over discharged (please
refer to the battery
charge condition),
please recharge the two
batteries at once before
use again or storage.
At least one battery is
hot, wait for them cool
down before start again.
The machine is over
load. Remove tool from
cutting area and try again.
13
EN