Assembly & Operation - Worx WG284 Mode D'emploi

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for cutting and
trimming hedges and bushes in domestic use.
Warning! Do not use the product
without attaching the guard and
front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR
CORDLESS HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
12 Checking the battery charge
condition
NOTE : Fig. C only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the
two batteries at same time.
More details can be found in
charger's manual.
Installing and Removing the
battery pack
NOTE :
• This machine will only
run when 2 batteries are
installed. It is recommended
to use the same two batteries
and charge the two batteries
at the same time.
• Using two different sized
batteries or if one battery
isn't fully charged then
the machine will only run
to the lowest common
denominator.
Cordless Hedge Trimmer
OPERATION
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is
illuminated, your battery
is overly discharged, even
though the trimmer may still
be capable of hedge trimming.
Continuing to operate your
trimmer with the battery in
this discharged condition
may reduce the life and
performance of your battery.
When no light is illuminated,
at least one battery is not
FIGURE
fully installed or battery may
be defective, please double
check the batteries are fully
seated into position.
See Fig. A
Remove the blade sheath
See Fig.
Starting and stopping
B1, B2
Rotating rear handle
NOTE :
• Unlock the locking switch
before rotating.
See Fig. C
• After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
• Always make sure that
the handle is locked in the
See Fig. D desired position before
operation.
• Always make sure the locking
switch is locked before
starting the hedge trimmer.
• Do not rotate the handle
when the trimmer is being
operated.
Top cutting
See Fig. E
ken, do not operate your hedge
trimmer until all damaged parts
have been replaced or repaired.
Failure to do so could result in
serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE
AND SAFETY GUARD.
WARNING:
WARNING: If any parts are
missing, damaged or bro-
See Fig. F
See Fig. G
See Fig.
H1, H2
See Fig.
I1, I2
See Fig. J
EN