Placing A Call; Answering A Call - Yealink SIP-T46G Guide De Démarrage Rapide

E
Basic Call Features
N
G

Placing a Call

L
Using the handset:
I
1. Pick up the handset.
2. Enter the number, and then press the Send soft key.
S
Using the speakerphone:
H
1. With the handset on-hook, press
2. Enter the number, and then press the Send soft key.
Using the headset:
1. With the headset connected, press
2. Enter the number, and then press the Send soft key.
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by
pressing the HEADSET key, Speakerphone key or by picking up the handset. Headset mode requires a
connected headset.

Answering a Call

Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press .
Note: You can ignore an incoming call by pressing the Reject soft key.
Ending a Call
Using the handset:
Hang up the handset or tap the End Call soft key.
Using the speakerphone:
or tap the End Call soft key.
Press
Using the headset:
Tap the End Call soft key.
Redial
to enter the Placed call list, press
Press
or the Send soft key.
Press twice when the phone is idle to dial out the last dialed number.
Call Mute and Un-mute
Press to mute the microphone during a call.
Press again to un-mute the call.
Call Hold and Resume
To place a call on hold:
or the Hold soft key during an active call.
Press
To resume the call, do one of the following:
If there is only one call on hold, press
4
.
to activate the headset mode.
or to select the desired entry, and then press
or the Resume soft key.