Yealink SIP-T46G Guide De Démarrage Rapide page 7

Accessing the web user interface:
1. Press the OK key when the phone is idle to obtain the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10") and then press the Enter key.
3. Enter the user name (default: admin) and password (default: admin) in the login page and
click .
Network Settings: Click on
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If your phone can not contact a DHCP server for any reason, you need to
configure the IP address, subnet mask, gateway address, primary DNS
address and secondary DNS address for the phone manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the account and password.
Note: The wrong network settings may result in the inaccessibility of your phone and may have an impact on
the network performance. Contact your system administrator for more information.
Account Settings: Click on Account->Register->Account X (X=1, 2, 3, 4, 5, 6)
Parameters of the account:
Register Status: It shows the register status of the current account.
Line Active: You can select Enabled/Disabled to enable/disable the account.
Label: It is shown on the LCD to identify the account.
Display Name: It is shown as caller ID when placing a call.
User Name: It is provided by ITSP for registration (required).
Register Name: It is an authenticated ID for authentication provided by ITSP (required).
Password: It is provided by ITSP for registration (required).
Server Host: It is provided by ITSP for registration (required).
Register status icons on the touch screen:
(Green) Registered
Note: Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Network Settings:
Press the Menu soft key when the phone is idle, select
Account Settings:
Press the Menu soft key when the phone is idle, select
to configure the account.
Note: For more information on account parameters, refer to
(Gray) Register Failed (Yellow) Registering
to configure the network.
.
E
N
G
L
I
S
H
3